Devices identified by DECK Monitoring Engineering as inducing noise into the Modbus network shall require each require one (1) approved RS-485 Optical Isolator.

Network wiring shall be executed with cable approved by DECK Monitoring.

Network shall include cable termination per Modbus protocol specifications.

Network shall originate from a single Bus Master device.

Devices shall be networked as a single bus.

Please refer to the table below for cable recommendations from DECK Monitoring:ĭECK Monitoring recommends that you observe each of the following standards for network wiring: We recognize that environmental noise at some project sites can lead to issues that may require additional hardware and labor. The items in this document are presented as points of interest to designers and installers of Modbus networks.ĭECK Monitoring recommends this cable and network wiring method in an attempt to provide a stable bus for Modbus RTU communications. Many of the more common problems associated with RS485 network stability can be mitigated by following these recommendations for wiring, termination and line bias. Engineers at DECK Monitoring have reviewed information from many sources to create the following recommendations for a standard and robust wiring method. Several cables and wiring methods are referenced by installers when deploying Modbus communications networks. Installation andĮlectrical wiring should be done by a licensed electrician who has experience working with energy monitoring equipmentĬable Termination (RS485/Modbus RTU Line Termination Resistor)Ĭable Termination (RS485/Modbus RTU Line Bias) Overview This document from DECK Monitoring suggests Engineering Standards for RS-485/Modbus RTU network wiring.ĭECK Monitoring provides information about installation in good faith, but DECK is not responsible for installation.

Modbus rtu wiring diagram